News

Conveyor Replacement Method?



First, cut off the old belt at the tail and punch the end of the old belt away from the exit and clamp the end of the belt with a cleat;

Second, replace the old outlet at the outlet of the conveyor belt to cut off the old one to form the long-distance and short-distance ones;

Third, the tweezers set at the belt replacement, the replacement tug connected to the conveyor bracket;

Fourth, the long section of the old belt from the end near the exit of the belt for the beginning through the pulley;

Fifth, use the sling to the beginning of the long section of the old belt, then hook the long section of the old belt to lift;

Sixth, when the long section of the old lift to the limit of the trip, will be pulled away from the replacement of the long section of the belt placed on the ground, and then move the belt to the belt replacement exit and repeat step five;

Seven, measure the guide wheel to the annular conveyor belt replacement wheel distance, according to the measured distance to the remaining unchangeable new conveyor belt cutting;

Eight, the remaining for the replacement of the new belt with the end of the old belt away from the replacement outlet through the splint connection;

Nine, the short section of the old belt from the end near the exit for the beginning through the belt tugboat;

Ten, with a sling to the beginning of the short section of the old belt cover, and then hook the short section of the old belt to pull up;

11, when the short section of the old lift to the limit of the old belt, the belt has been pulled off the replacement of the short section of the old belt placed on the ground, and then move the belt to the belt replacement exit and repeat step ten;

12, when the long section of the old conveyor belt, short section of the old belt after the removal is complete, it will be connected to the need to update the conveyor belt, and the long section, the short section of the old band plywood removed, and the new band can be glued to both ends carry out.